Installation

The Air Wing includes a dedicated adapter that works with almost all A/C models. No screws or drilling is needed, so there are no worries about damage to ceilings and walls. Before installing, simply wipe down the attachment area with water or a neutral detergent, dry and then attach. It’s so easy, anyone can install the Air Wing with a single touch.

Installation Procedure

Installation procedure

1. Loosen the screws and adjust the joint height and angle. (Making adjustments without loosening the screws causes wear between the contact surfaces, resulting in sagging.)

2. Attach the adapter to the attachment location with two-sided tape. After attaching, let it sit for 10 minutes and then confirm that it is securely fastened.

3. Insert the joint portion into the insertion slot.

Notes

Before attaching the adapter, clean the attachment surface with water or a neutral detergent, remove any oily or gritty substances (including dust) from the surface, and dry thoroughly. The Air Wing may drop if water drops or dirt remains when the adapter is attached. (Reattachment may also cause the unit to fall.) After the adapter is attached, insert the joint section into the adapter for one-step installation.

The dedicated adapter fits outlet louvers perfectly, making the Air Wing Slit an excellent choice for almost all A/C units with a slit-type air outlet. The adapter and Air Wing Slit unit simply snap together for use. There is no need for screws, drilling or any other construction for installing on the A/C, so there are no worries about damaging ceilings and walls.

The Air Wing Slit with accessories

The Air Wing Slit with accessories

The Air Wing Slit with accessories

To attach, simply squeeze the adapter and hang on the inside of the louver.

To attach, simply squeeze the adapter and hang on the inside of the louver.

The Air Wing arms can be moved 180 degrees forward and back, as well as up and down. Set the desired wind direction to match the layout of your office, store, hospital or home. The arms are adjusted differently depending on whether cooling or heating is being used. For heating, direct warm air toward the foot area. The factory default setting is for cooling, so refer to the User’s Manual and adjust as appropriate.

Set the desired wind direction to match the layout of your office, store, hospital or home.